Waste Tank Warning Light; Brush Pressure / Load Adjustment; Emergency Stop Button And Horn - Numatic TRO 650 Mode D'emploi

Brush pressure / Load adjustment

NOTE: The run-time of the machine may decrease
if the load on the brushes is increased.
Emergency-stop button and horn
Fig.26
ALWAYS ENSURE THAT THE FLOOR IS PRE-SWEPT
!
AND RELEVANT SAFETY SIGNS ARE DISPLAYED.
Machine Operation / Bedienung der Maschine /
Fonctionnement de la machine / Bediening van de machine
When the waste water-tank becomes full, a red warning light will illuminate on the
operator control panel (as illustrated) and the vacuum motor will stop automatically
after 5 seconds. The waste-water tank requires emptying (see page 32).
The machine is equipped with a brush-pressure load-warning system.
manually by the operator using the adjuster knob found on the left hand side of the control
column.
Turn it anti-clockwise to decrease load on the brushes and clockwise
to increase load / pressure on the brushes (see Fig.25).
The TRO 650 is equipped with an electronic braking system.
Simply lift your foot from the accelerator and the machine will stop.
In an emergency, strike the emergency-stop isolator button
The machine will be disabled.
To reset, turn isolator button clockwise (see Fig.26).
After resetting the emergency stop button, to restart the
machine ,turn the ignition key to the off then the on
position again.
The horn is located on the right-hand side of the operator
control panel (see Fig.26a).
26
Fig.25
Fig.26a
!