Operation; To Operate The Product - Bright 025125 Traduction Des Instructions D'origine

3

Operation

3.1 To operate the product

Warning! The water container must be intended for
cooking and be at least 11 cm high.
1
Attach the product to a water container. Use the clip
on the product. Make sure that the control panel is
visible.
Warning! Do not fill water up to the maximum marking
on the product. The water level will increase when you put
the food items in the water.
2
Fill the water container with water until the water
level is in between the minimum and maximum
markings on the product.
3
Connect the power plug to a power outlet. All status
lights will come on for 1 second and a long beep is
given. The power switch lights up red.
4
Push the power switch symbol to activate the
temperature adjustment mode. The default
temperature, 50°C, is shown on the display.
5
Push the increase or decrease temperature/time
buttons to adjust the target temperature. The
temperature range of the product is 30–95°C.
Note! Push and hold the increase or decrease temperature/
time buttons adjust the target temperature faster.
6
Push the temperature/time button to activate the
hour setting mode. The default time, 03:00, is shown
on the display.
7
Push the increase or decrease temperature/time
buttons to adjust the hours. The hour range of the
product is 0–99 hours.
Note! Push and hold the increase or decrease temperature/
time buttons to adjust the hours faster.
8
Push the power switch symbol to activate the minute
setting mode. The digits flashes.
22
9
Push the increase or decrease temperature/time
buttons to adjust the minutes. The minute range of
the product is 0–59 minutes.
Note! Push and hold the increase or decrease temperature/
time buttons to adjust the minutes faster.
Warning! Risk of burn injury. The bottom part of the
product becomes hot when the product operates. Do not
touch the hot parts of the product.
10
Push the power switch symbol. The product starts to
heat the water to the target temperature.
Note! Push the temperature/time button when the product
operates to check or reset target temperature and time.
Note! When the product operates push and hold the power
switch button for 2 seconds to make the product enter
standby mode.
11
Wait until the water is at the target temperature. A
long beep is given when target temperature has been
reached. The time starts to count down automatically.
Warning! The water is hot. Do not touch the water
with your hands.
Warning! Do not put food items directly in the water.
Use approved bags that are intended for cooking.
12
Put the food items in the water. When the cooking
time has been reached, 3 beeps are given and the
product goes into standby mode.
13
Disconnect the power plug from the power outlet.
Warning! The water is hot. Do not touch the water
with your hands.
14
Remove the food items from the water.
2023_001