Throttle Trigger; Maintenance; Maintenance Schedule - Husqvarna BP152HV Manuel D'utilisation

To use the throttle trigger
• To increase the blower speed during operation, push
the throttle trigger until you get the correct speed.
(Fig. 30)
• To decrease the blower speed during operation,
release the throttle trigger until you get the correct
speed.
To start the engine when the fuel is too
hot
If the product does not start, the fuel can be too hot.
Note:
Always use new fuel and decrease the
operation time during warm weather.
1. Put the product in a cool area away from open
sunlight.
2. Let the product cool down for 20 minutes at
minimum.
3. Press the air purge bulb again and again for 10-15
seconds.
4. Obey the procedure to start a cold engine. Refer to
To start a cold engine on page 11 .
To operate the product
• Operate the product at usual work hours. Obey local
regulations.
• Decrease the pieces of equipment and select the
correct speed for your task. Use the throttle at lowest
position possible to prevent more noise and dust
than necessary.
• Keep the blower nozzle near the ground.
Note:
Husqvarna recommends that you use the
full blower nozzle extension.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.

Maintenance schedule

Maintenance

Clean the external surfaces.
Make sure that the control handle operates correctly.
Make sure that the start/stop switch operates correctly. Refer to
the start/stop switch on page 9 .
12
Maintenance
Read and understand the
• Make a note of the wind direction and operate the
product in the direction of the wind.
• Use applicable garden tools to release material from
the ground.
• In areas with dust, use spray equipment to wet the
area. This decreases the operation time.
• After operation, keep the product in storage
vertically.
To stop the product
CAUTION:
full speed.
1. Push the stop switch. (Fig. 31)
Note:
When the product stops, you can hear a
knock sound. This is typical and is not an indication
of a defective product.
To adjust the harness
1. Put on the harness of the product.
2. Put the waist belt around your waist and connect the
belt buckle for the waist strap. (Fig. 32)
3. Tighten the waist belt strap. (Fig. 33)
4. Connect the belt buckle for the chest strap. (Fig. 34)
5. Adjust the position of the chest strap. (Fig. 35)
6. Tighten the chest strap. (Fig. 36)
7. Tighten the shoulder straps until the product is tight
against your body. (Fig. 37)
8. Tighten the load lifter straps. (Fig. 38)
To do a check of
Do not stop the product at
Daily Weekly Monthly
X
X
X
1456 - 004 - 28.05.2021