Publicité
Les langues disponibles
Les langues disponibles
Power steering parts
2 INSTALLATION
2.1 REMOVING THE PACKING
The machine is delivered inside a box suitable for the
purpose.
Therefore, the packing must be removed completely by
means of suitable tools and care must be take in order to
avoid damage to any part of the machine.
For packing disposal, please refer to 6.4 point.
2.2
HANDLING AND TRANSPORTION (Fig. 2)
Check Moved the machine carefully paying attention to
serious Bumps and shocks during handling being a
delicate machine.
2.3 ELECTRICAL CONNECTIONS
Check that the mains to which the machine is connected is
earthed in accordance with current safety regulations and
that the power point is in good condition.
Connect a plug in compliance with safety rules to the
end of the mains cable of the machine, checking that the
yellow/green protective conductor is fitted into the relative
terminal marked.
Remember that there should be a magnetothermic
protective device fitted upstream of the mains to protect all
the conductors from short circuits and overloads.
This protective device should be selected according to the
electrical features of the machine.
UNIVERSAL VERSION (Fig. 4)
In case of power failure in mains, while you wait for power
to be restored there is no danger hazard may arise : in
fact, the computer is also equipped with a
reset function which prevents the machine from re-starting
automatically. To start the machine select the proper
function.
WARNING: Never change setting to avoid
overloads which could damage the electric
circuits and other mechanical parts.
Your machine is equipped with a r protection
obtained through fuses limiter which prevents the EPS
EHPS from absorbing a current higher than the set one,
expressed by the maximum prescribed value of
absorption.
2.4 POSITION/WORK STATION (Fig. 2)
Position the machine by moving it as described in
paragraph 2.2
Taking the ergonomic criteria into consideration, the ideal
height shall be that which enables you to position the
table between 90 and 95 centimetres from the floor (see
Fig. 2).
CAUTION: Make sure that the machine is placed
in a working area with suitable
environmental conditions and lighting.
The general conditions of the working
environment are of fundamental
importance for accident prevention.
ATG - Eps Testing system
3 INSTRUCTIONS
3.1 DISPOSAL OF THE MACHINE AND
PACKAGING
INFORMATION FOR USERS
In accordance with art. 13 of Legislative
Decree
25th July 2005, no. 151 "Implementation
of
Directives 2002/95/EEC, 2002/96/EEC and 2003/108/
EEC, relative to reducing the use of hazardous
substances
in electrical and electronic appliances and the disposal of
waste", please take note of the following:
• The crossed out wheelie bin symbol found on the
appliance or on the packaging, indicates that the product
must be disposed of separately from ordinary household
waste when it reaches the end of its working life.
• The user must consign the unwanted appliance to
an authorized differentiated waste disposal centre for
electrical and electronic goods, or alternatively, hand
it over to the relative dealer on purchasing a new
appliance of the same type on the basis of a one to
one ratio.
• Differentiated disposal, to enable possible recycling
or environmentally compatible elimination of the
appliance, helps to limit undesirable effects on health
and the environment and promotes the reuse and/or
recycling of the materials which went into making up
the appliance.
WARNING: Sanctions, in accordance with
the relative legislation in force in the
country of use, will be imposed on the user
if the appliance is disposed.
Publicité
