Cleaning And Care; Changing The Carbon Brushes - Unitec 230 V PREMIUM Mode D'emploi Original

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Warning! Always disconnect the tool from the mains supply before
cleaning or care so as to reduce the risk of injury. Never try to repair
the tool yourself.
• Pull the mains plug (2) out of the mains socket.
• Remove the socket spanner (6) from the socket spanner holder (5).
• Clean dirt and dust off the ventilation slits.
• Use a mild soap and a damp cloth to clean the impact wrench's housing and
handle (1). Always keep the handle free of oil and lubricating grease.
• We recommend keeping the tool and accessories in the carry case (7) in a
clean, dry location.
• If the mains cable of this device is damaged, it must be replaced by the
manufacturer or its Customer Service or a similarly qualified person so as to
avoid hazards.
Warning!
• Do not use any cleaning agents, alcohol or thinners to clean the
tool. These might damage the plastic parts and other insulated
parts of the tool.
• Never use flammable or combustible thinners in the vicinity of
the tool!
• Never immerse the tool in liquids and make sure that no liquids
can seep into the tool.
Switch the device off. Pull the mains plug out of the socket.
If a carbon brush is so worn out that the plastic insulation pin inside touches
the collector, the motor is automatically switched off. If this occurs, both carbon
brushes must be replaced at the same time. Use only identical carbon brushes.
To guarantee the safety and reliability of this machine, repair, maintenance and
adjustment work should only be carried out in workshops or customer service
centres authorised by the manufacturer using only the manufacturer's original
spare parts.
10923_Schlagschrauber_BA_141205.indd 29
7. Cleaning
and care
7.1 Changing the
carbon brushes
29
05.12.14 11:04

Publicité

Table des Matières
loading

Table des Matières