Troubleshooting - Husqvarna LC 353AWD Manuel D'utilisation

Masquer les pouces Voir aussi pour LC 353AWD:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Problem
The engine does not start.
The engine does not stop.
The engine does not operate
smoothly.
The engine becomes too hot.
There is misfire in the engine
when it operates at high speed.
The engine does not operate
smoothly at idle speed.
There is too much vibration in the
handle.
1242 - 003 - 01.11.2019

Troubleshooting

Possible cause
The ignition cable is not connec-
ted correctly.
The fuel tank is empty.
There is dirt in the carburetor or
fuel line.
The spark plug is defective.
The stop mechanism is defective. Disconnect the ignition cable from the spark
The ignition cable is not connec-
ted correctly.
There is dirt in the fuel line or the
fuel has expired.
There is blockage in the fuel tank
cap.
There is water or dirt in the fuel
system.
The air filter is dirty.
The carburetor must be adjusted. Let a servicing dealer adjust the carburetor.
The engine oil level is too low.
The air flow is not sufficient.
The carburetor must be adjusted. Let a servicing dealer adjust the carburetor.
The electrode gap in the spark
plug is too small.
The spark plug is dirty, defective
or the electrode gap is too wide.
The carburetor must be adjusted. Adjust the carburetor.
The air filter is dirty.
A blade is loose or not balanced.
A blade is bent.
Solution
Connect the ignition cable to the spark plug.
Fill the fuel tank with correct fuel type.
Clean the carburetor and/or fuel line.
Adjust the electrode gap, clean or replace
the spark plug.
plug. Let an approved service agent repair
the product.
Connect the ignition cable to the spark plug.
Clean the fuel line. Fill the fuel tank with new
fuel of the correct type.
Clean the fuel tank cap.
Drain the fuel tank. Fill the fuel tank with new
fuel of the correct type.
Clean the air filter.
Fill engine oil.
Clean the air filter and the air filter housing.
Adjust the electrode gap.
Adjust the electrode gap or replace the spark
plug.
Clean the air filter.
Tighten the blade bolts. Replace the blades if
there are damages.
Replace the blades if there are damages.
17

Publicité

Table des Matières
loading

Table des Matières