Operation - Delta SA350K Manuel D'utilisation

OPERATIONAL CONTROLS AND ADJUSTMENTS
STARTING AND STOPPING THE SANDER
The on/off switch (A) Fig. 12 is located on the sander
base. To turn the sander "ON", move the switch up to
the "ON" position. To turn the sander "OFF", move the
switch down to the "OFF" position.
LOCKING THE SWITCH IN THE "OFF" POSITION
IMPORTANT: When the machine is not in use, the
switch should be locked in the "OFF" position to
prevent unauthorized use. To lock the machine, grasp
the switch toggle (B) and pull it out of the switch (Fig. 13).
With the switch toggle (B) removed, the switch will not
operate. However, should the switch toggle be removed
while the sander is running, the machine can be turned
"OFF," but cannot be restarted without re-inserting the
switch toggle (B).
ADJUSTING THE SPINDLE ASSEMBLY
If excessive play develops in the spindle assembly, or
if noise level increases after extended use, adjust the
spindle assembly.

OPERATION

FIG. 13
A
9
A
FIG. 11
B
B
C
D
E
F
A