Publicité
Les langues disponibles
Les langues disponibles
EN
TECHNICAL DATA
Minimum dynamic pressure:_______________________________________________________________0.5 bar
Maximum operational pressure:______________________________________________________________5 bar
Recommended operational pressure:_______________________________________________________1-5 bar
It's recommended to use a pressure reducer in case of
static pressure superior than 5 bar inside the waterpipe.
Maximum hot water temperature:____________________________________________________________80°C
INSTALLATION, MAINTENANCE AND PRELIMINARY CHECKING PROCEDURE
In order to get your device work correctly and fi ne in time, must ensure compliance with the mode
of installation and maintenance described in this booklet. Relying on a qualifi ed plumber. Make sure
that the system is free from all debris and impurities existing.
INSTALLATION
Fig. 1: Make two holes MIN Ø27 mm - 1.06 in, MAX Ø33 mm - 1.3 in into the support base in order to
put the handles. Operating from the bottom of the base, insert the sidebody valve and the fi xing set.
From the upper side, position the OR and the covering support. Screw the reduction component on
the sidebody valve. Insert the handle by using the screw verifying the right opening/closing position.
Lay the sidebody valve into the support and block it with the grub screw. Place the fi xing kit.
Fig. 2: Insert the marble cover on the support, fi xing it with the grub screw. Screw the lateral lever and
verify the correct movement. Repeat the procedure for the other handle.
Fig. 3: Make a 35mm - 1.37 in hole on the support base. From the upper side of it, insert the stem
of the spout into the hole just created, positioning the OR. Stabilize the spout by using the proper
fi xing kit.
Fig. 4: Link the sidebody valves to the spout by using the fl exibles. Connect the sidebody valves to
the hydric system.
CLEANING
Diversify the cleaning of the chromed parts from the marble ones.
Due to the fact that marble is precious and fragile, we suggest to cover it up with a towel during the
cleaning process of the metallic parts.
Chromed metallic parts
In order to obtain a correct cleanliness, exclusively wash them with soap and water, rewash and dry
them with a soft towel and deerskin. Avoid the usage of alcohol, solvents, solid or liquid detergents
which contain corrosive or acidic substances, abrasive sponges, swab with metallic strings because
they could irreversibly compromise the surfaces.
Marble parts
Use water with a low alcohol concentration to clean the marble parts, otherwise use a soap with a
neutral PH. Avoid the usage of all the acidic substances. Do not use lemon juice, citric acid, wine vi-
negar, apple vinegar, aggressive detergents and other solutions which may result acidic or corrosive.
DON'T LET THE MARBLE PARTS GET IN TOUCH WITH ANTI-LIMESCALE PRODUCTS due to the fact
that marble is a calcareous rock and it would be corroded. Avoid abrasive products and all the things
that could scratch the marble and wreck it irreversibly.
THE USAGE OF THIS KIND OF DETERGNETS DURING THE CLEANING OF THE MIXER EXCLUDE IB
RUBINETTERIE FROM ANY WARRANTY OBLIGATION.
Publicité
