Maintenance - Sandri Garden SG 1225/25 CS Instructions De Service

GB
PEtROL CHAiN SAW FOR tREE SERViCE USER MANUAL
Before starting each job:
- check manually that the lever click releases both
forwards and backwards.
- put the chain saw on a safe surface.
- start the engine.
- engage the brake (fig 30).
- take with both hands.
- push deeply the throttle trigger for very few time
(around 2 seconds)if the chain starts moving, if
the clicks are not released or the chain brakelever
becomes hard, do not use the chain saw.
Please ask to a qualified service center
- Periodically take off the chain brake cover (fig.1
item 19) to remove shavings and sawdust.
Do not attempt repairs or modifications.
8.11 FUEL MIX ADJUSTMENT
ENGINE "IDLE" SPEED ADJUSTMENT
SCREW [t]
- The fuel of your chain saw has been factory set
on standard values (fig.21).
- The screw [t]: keeps the butterfly valve in a
slightly open position in order to adjust the engine
"iDLE " speed at the correct rotation speed.
WARNiNG DANGER!! A high "idle"
speed adjustment can cause the operation of
the centrifugal clutch and therefore operate
the cutting chain even if the throttle lever is
released.
- The engine idle speed is increased by turning
the screw clockwise.
- See the technical data table (page 23).
62
- Screw [L]: adjusts the carburation for the idle
speed and acceleration.
- Screw [H]: adjusts the carburation for the high
operating speed.
As the adjustment operation requires a
technical background as well as special techni-
cal equipment, please contact an APPROVED
SERViCE CENtRE.

9. MAiNtENANCE

DANGER!! Do not carry out any check-
ing, maintenance and repair operations
with the engine running.
9.1 CHAiN
MAiNtENANCE AND SHARPENiNG
- If the chain is correctly sharpened, using the
chain saw will be effortless, a better cutting
performance will be achieved, and no excessive
wear and tear of the mechanical parts and of the
guide bar will occur.
- If the chain is under-lubricated, increase the
oil flow by turning the oil pump adjusting screw
anticlockwise (fig.19).
- Before sharpening, the chain must be
taut by means of the chain tensioner
(fig.10) see chapter "INSTALLING THE
GUIDE BAR AND CHAIN".
- After sharpening, slacken the chain by following
the installation instructions.
- During the sharpening operation, lock the chain
in position by applying the brake.
- Use a round file (specially designed for chains)
with a 5/32" (4.0 mm) diameter, fig.20 item 1.
Check the sharpening angles as shown in (fig.20
items 2-3).