Sandri Garden SG 1225/25 CS Instructions De Service page 57

PEtROL CHAiN SAW FOR tREE SERViCE USER MANUAL
1
CAUtiON-HAZARD! the cutting chain
moves because the throttle trigger is
partially advanced.
- Hold the chainsaw firm (Fig.34) letting the
engine and chain run for at least 15 seconds (for
pre-heating).
10) Using the palm of your hand, press the throttle
trigger lock-out (fig. 36 part. 1) and then press
the throttle trigger (fig. 36 part 2); this way "tHE
tHROttLE ADVANCEMENt" will disengage
and the engine will run at minimum speed.
11) Do not use the chainsaw if the chain
moves at the minimum engine setting.
Instead, apply to a service centre for assistance.
12) Do not move or transport the chainsaw
with the engine running.
During transport, cover the bar with the protector
provided.
StOPPiNG tHE ENGiNE
1) To stop the engine, lower the switch lever to
the "0 " position (Fig.27).
StOP
2) After using the chain saw for long periods of
time, it is advisable to let the engine run at idle
speed or several seconds before operating the
"0 " switch lever.
StOP
AttENtiON! Accustom yourself to
Fig.35
operating the StOP switch so that you will be able
to act promptly in the event of an emergency.
AttENtiON! The chain will continue
to move for some time after the throttle lever is
released.
StARtiNG A WARM ENGiNE
1) Raise the switch lever "i" (Fig 31 part.1).
2) Pull the air knob as far as it will go and then
push it in to engage "tHROttLE ADVANCE-
MENt" - StARt.
3) Give the starter cord handle a strong pull until
the engine starts fig. 34.
StARtiNG WitH tHE ENGiNE HOt AFtER
REFUELLiNG
1) If the fuel tank has been emptied completely,
after refuelling follow the instructions given for
"StARtiNG WitH tHE ENGiNE COLD ".
StOPPiNG tHE ENGiNE. the engine must
1
2
GB
Fig.36
57