Cleaning And Maintenance - emerio PAC-125216.3 Mode D'emploi

2) Please cut off the power supply, move the appliance to a suitable place, pull out the stopper in the drain
port to drain the water completely. If conditions permitted, you can also connect the drain hose to the
drain port for the water draining.
3) After the draining, insert back the stopper to the drain port, otherwise the appliance may leak and make
your room wet.

CLEANING AND MAINTENANCE


Before cleaning, be sure to disconnect the appliance from any electric supply outlet.

Do not use gasoline or other chemicals to clean the appliance.

Do not wash the appliance directly.

If the appliance is damaged, please contact the dealer or repair shop.
Air Filter
If the air filter becomes clogged with dust/dirt, the air filter should be cleaned once every two weeks.
- Pull out the air filter from the air inlet grille by the pull tab.
- Clean the air filter with neutral detergent in lukewarm water (< 40℃) and dry it up in the shade.
- Reinstall the air filter.
Clean the Surface
First clean the surface with a neutral detergent and wet cloth, and then wipe it with a dry cloth.
TROUBLESHOOTING
Troubles Possible Causes
The doors or windows are not closed.
There are heat sources inside the room.
The hot air exhaust hose is not connected
Not cool enough
or blocked.
Temperature setting is too high.
Air inlet is blocked.
The ground is not level or not flat enough.
Noisy
The sound comes from the flowing of the
refrigerant inside the appliance.
Code "E2" on the
Room temperature sensor failed.
digital display
Code "E3" on the
Evaporator temperature sensor failed.
digital display
Code "E4" on the
Water-full warning
digital display
Solutions
Make sure all the windows and doors
are closed.
Remove the heat sources if possible.
Connect or clean the hot air exhaust
hose.
Reset the temperature.
Clean the air inlet.
Place the appliance on a flat, level
surface if possible.
It is normal.
Replace the room temperature sensor.
Contact authorized service technician
for repair.
Replace evaporator temperature sensor.
Contact authorized service technician
for repair.
Drain out the water.
- 10 -