EDMA INSULACUT Guide D'utilisation page 20

CHARGER LED FUNCTIONS
Power ON
The LED will stay GREEN when the charger is plugged into a "live" power source.
Battery partially charged
The LED will stay RED during charging.
Battery fully charged
When the battery is approximately 100% charged, the red LED will turn green. The green
LED indicates the charger has completed the charging cycle.
Under normal circumstances, the battery will be fully charged in approximately
90-100 minutes.
Defective battery
The LED will stay GREEN and cannot turn red when a defective battery is charged and it
should be replaced. .
Too hot or too cold
When the work area or battery temperature is too high or too low, remove the battery from
the charger and store it in 21° C (70° F) room temperature for about one hour, and resume
charging.
INSTALLING A BATTERY IN THE RECIPROCATING SAW
3. Remove the discharged battery (1) from the tool by pressing on the battery release
button (2) on the top of the battery.
4. Slide the fully charged battery into the matching cavity in the tool handle where the
discharged battery has been removed.
NOTE : the battery release button will "click" into place when the battery is fully installed
!
WARNING :
cause the hot battery to explode or leak.
do not immerse the battery pack into the water. Sudden cooling could
20
.