Charging The Battery Pack - EDMA INSULACUT Guide D'utilisation

CHARGING THE BATTERY PACK

!
WARNING :
the 14.4V Li-ion battery supplied with the tool. Charging any other batteries with this
charger may damage the charger, and possibly cause serious injury.
4. To charge the battery, place the charger (1) in a dry location near a 230V/50 Hz
electrical outlet
5. The battery charger plugs into the hole of the battery (2).
NOTE : make sure the charger plugs into the hole well.
6. Plug the battery charger into the 230V/50 Hz wall receptacle.
NOTE : do NOT charge batteries when the work area or the battery temperature is at or
below 0°C (32° F) or above 45°C (113° F).
ASSEMBLY AND OPERATING
use only the diagnostic charger supplied with the tool to charge
1
2
19