Battery & Charger Safety - EDMA INSULACUT Guide D'utilisation

!
WARNING :
the 14.4V Li-ion battery. Charging any other batteries may damage the charger.
Never attempt to open the battery for any reason. If the housing of the battery breaks or
cracks, immediately discontinue use and do not recharge.
Do not charge the battery if it is wet or shows any evidence of corrosion.
A small leakage from the battery may occur under extreme usage, charging or temperature
conditions. This does not indicate a failure. However, if the outer seal is broken and this
leakage gets on your skin, follow these steps :
1. Wash immediately with soap and water.
2. Neutralize with a mild acid such as lemon juice or vinegar.
3. If the liquid gets into your eyes, flush immediately with clean water for a minimum of
10 minutes and seek medical attention.
NOTE : the battery liquid is slightly acidic.
Do not incinerate the battery because it can explode.
Do not use an extension cord. Plug the charger cord directly into an electrical outlet.
Use the charger only in a standard 230V/50 Hz electrical outlet
Do not use the charger in wet or damp conditions. Do not immerse the charger into the
water.
The charger should be placed away from sinks and hot surfaces.
Do not use the charger to charge any batteries other than the oscillating tool batteries.
Other batteries may explode.
Do not operate the charger if the cord or plug is damaged.
Do NOT charge the batteries when the work area or the battery temperature is at or below
0° C (32° F) or above 45° C (113° F).
Unplug the charger when not in use and before cleaning.
BATTERY & CHARGER SAFETY
only use the diagnostic charger supplied with this tool to charge
16
.