Publicité
English
Technical Specifications
Recommended water pressure
Max. water pressure
Recommended hot water temp.
Max. hot water temp
Flow rate:
Rain AIR (outer portion of shower) 2 .5 GPM max.
Rain AIR (inner portion of shower) 2.5 GPM max.
Whirl AIR
*Know and follow all applicable local plumbing codes
when setting the temperature on the water heater.
Installation Considerations
• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly be-
fore beginning installation. Make sure that you
have all tools and supplies needed to complete
the installation.
• This unit should be installed with iBox Universal
Plus rough 01850181 with thermostatic mixer
trim and ¾" volume control rough 15977181.
Trim kits are specified and sold separately.
Rough valves and trims are not included with the
Raindance Imperial.
• This showerhead must be installed with Quattro
Green diverter #15936181 (included with the
28412181 rough valve).
• The Quattro Green insures that the total flow rate
of the showerhead does not exceed 2.5 GPM
at any setting. It does not permit the use of two
functions simultaneously.
• The trim kit for the Quattro Green is sold
separately.
• The Raindance Imperial basic set #28412181
must be installed in the ceiling prior to the instal-
lation of the finishing material (tile, marble, etc.).
• Install the thermostatic mixer, volume control and
Quattro Green diverter according to the installa-
tion instructions. Run three ½" lines from outlet
2
15 - 75 PSI
145 PSI
120° - 140° F*
176°F*
2.5 GPM max.
• Additional features, such as a handshower and/
• Make sure that sufficient drain capacity is
• The screws and anchors provided are suitable for
• The 28403001 showerhead weighs ap-
• This showerhead is for use with automatic com-
• To prevent scald injury, the maximum output tem-
• Keep this booklet and the receipt (or other proof
This unit meets or exceeds the following:
•
ASME A112.18.1
•
CSA B125.1
•
Listed by IAPMO for use in the US
and Canada
ports on the Quattro to supply the Raindance
Imperial. At the ends of the lines, attach ½"
straight connectors, which will connect to the sup-
ply lines on the Raindance Imperial basic set.
or bodysprays may be added. However, ad-
ditional volume controls are required.
provided.
use in concrete. The installer must provide alter-
nate fasteners for use in other mounting surfaces.
proximately 25 lbs. Do not attempt to
install it alone. A helper is necessary.
pensating valves rated at 2.0 GPM (7.6 L/min)
or less.
perature of the shower valve must be no higher
than 120°F. In Massachusetts, the maximum out-
put temperature can be no higher than 112° F.
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
Publicité
