InnoCigs EGO AIO Mode D'emploi page 64

INNOCIGS EGO AIO – USING THE DEVICE
Adjusting the Air Supply
The air supply can be adjusted by rotating the ring on the clearomizer cap to the right or left. The more air flows into the
device, the lower is the drawing resistance. Pay particular attention to a sufficient air supply during sub-ohm vaping. If the
two marking points on the top cap are next to each other, the Airflow Control is open at the maximum. If the ring is turned
90°, the Airflow Control closes.
Attaching or Changing the Mouthpiece
The mouthpiece is attached to the cap on top of the clearomizer. The mouthpiece may be cleaned with warm water.
Make sure that it is completely dry before reinserting into the clearomizer.
62