inventiv INV-CSBL20-BM Notice De Montage page 40

OPERATION
1. HAND GRIP POSITION
Always hold your saw firmly with both hands when
operating.
2. SWITCHING ON AND OFF (SEE FIG. E)
When the lock-off button is in the neutral position,
the switch is locked. Press the lock-off button left or
right, then press the on/off switch, the machine starts.
To turn off the machine, release the switch, the lock
button is in the neutral position, and the machine
stops.
Your saw has an automatic electric brake which is
designed to stop the blade from coasting in about
three seconds, after you release the trigger switch.
It is useful when making certain cuts in wood where a
coasting blade would result in a wide, imprecise cut.
WARNING: Wait until the machine comes to a
complete stop before setting down.
3. PARALLEL GUIDE ADJUSTMENT (SEE FIG. F1, F2)
It is used for making cuts parallel to a workpiece edge
at a chosen distance. First turn the parallel guide
locking screw anti-clockwise with the provided hex
key to loosen, then slide the parallel guide arm through
the gap to achieve the desired cutting distance, then
turn the locking screw clockwise with the hex key to
firmly clamp the parallel guide.
NOTE: It is best to carry out a trial cut before cutting
your workpiece.
ORIGINAL INSTRUCTIONS
40
SAFETY AND OPERATING MANUAL
E
2
F1
F2
1