Publicité
Les langues disponibles
Les langues disponibles
6- Precautions for use
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book carefully.
INTENDED USE
This circular saw is intended for lengthways and crossways cutting of wood with straight cutting
lines as well as bevel angles to 45° while resting firmly on the work piece.
A1
2
A2
1
ORIGINAL INSTRUCTIONS
ASSEMBLY
1. CHANGING THE SAW BLADE (SEE FIG. A1-A2)
WARNING:
• Before any work on the machine itself, pull out the
mains plug.
• Wear protective gloves when mounting the saw
1
blade. Danger of injury when touching the saw
blade.
• Only use saw blades that correspond with
the characteristic data given in the operating
instructions.
• Do not use grinding discs as the cutting tool under
any circumstances.
NOTE: For changing the saw blade, it is best to place
the machine on the face side of the motor housing.
- Removing
Press the spindle lock button and keep it depressed.
The spindle lock button may be actuated only when
the saw blade is at a standstill.
2
Loosen the blade bolt in anti-clockwise direction with
the hex key. Remove the outer flange. Tilt back the
lower blade guard and hold it firmly with the lower
guard lever. Remove the saw blade.
- Mounting
Clean the saw blade and all the clamping parts to be
assembled.
Tilt back the lower blade guard and hold it firmly with
the lower guard lever. Place the saw blade onto the
inner flange. Assemble the outer flange and the blade
bolt onto the saw blade.
Press and hold the spindle lock button, and use
the hex key to tighten the blade bolt in clockwise
direction firmly.
WARNING:
• Take care that the mounting positions of the inner
flange and outer flange are correct.
• When mounting: Ensure that the cutting direction
of the teeth (direction of arrow on saw blade) and
the direction-of-rotation arrow on the blade guard
match.
37
SAFETY AND OPERATING MANUAL
Publicité
