Error Messages; Bluetooth ® Connection - Skandika Fitness SF-1890 Instructions De Montage Et Mode D'emploi

Error messages

"---- " " ----" means, that the contact to the handpulse sensors was not sufficiently for a
measurement. The reason for this can be that you have not grasped the two sensors correctly.
Start a new measurement with correctly placed hands!
"E-1" means, that no heart rate signal has been detected.
"E-4" appears, if the fat % or BMI values are too low (<5) or too high (> 50).
USB power charger
The computer can be used to charge your tablet or other mobile devices via the built-in USB
port.
Bluetooth connection
®
The computer can be connected via
apps. Please refer to the app instructions accordingly.
Remarks:
1. 1. The monitor will enter SLEEP mode when there is no signal and no key pressed for 4
minutes.
2. 2. If the USB power charging function or
consumption. We recommend to use an adaptor 9V 1.3A in this case.
3. 3. In case of any abnormal functions, disconnect the device from power source and recon-
nect after some minutes.
4. 4. In H.R.C or RECOVERY modes the user needs to hold on to the handsensors constantly
(or wear a compatible chestbelt) for proper pulse detection.
5. 5. If the computer is connect via
on again you need to disconnect the
42
Bluetooth
®
to communicate with iconsole+ or FitHiWay
Bluetooth
Bluetooth
® it will power off itself. If you want to turn it
Bluetooth
®
connection first.
® is used, there is a higher power