Recommended Cutting Equipment For Canada - Husqvarna 385XP Manuel D'utilisation

RECOMMENDED CUTTING EQUIPMENT FOR CANADA

The following is a list of recommended cutting equipment for Class 1A and 1B Chainsaws.
The combinations of powerhead, bar and chain meet all requirements outlined in the CSA Z62.1-95 Chainsaws and Z62.3-96
Chainsaw Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the corresponding
maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. For guide
bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of sprocket teeth may be
considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent or less
kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which are available
at your dealer.
Bar
Length,
Pitch, inch
inches
18-28 3/8"
18-28 3/8"
Note: For the chains above you are free to choose between 0,050", 0,058" and 0,063" gauge drive link for the corresponding bar,
see the table below.
0,050"/1,3 mm -
0,058"/1,5mm H42
0,063"/1,6 mm -
WARNING! This chain saw model is capable
!
of severe kickback that could result in
serious injuries to the user. Do not operate
this saw unless you have extraordinary
cutting needs and experience and
specialized training for dealing with
kickback. Saws with significantly reduced
kickback potential are available. Always use
the safest saw and cutting equipment
applicable to your cutting need.
TECHNICAL DATA
Chain
Max nose
radius
11T Husqvarna H42, Oregon 73LP / 73LG / 73V
ATM 1,33" Husqvarna H42, Oregon 73LP / 73LG / 73V
72LP 72LG 72V
73LP 73LG 73V
73LP 73LG 73V
– 37
Canadian