Wrangler 1710 AB Instructions D'origine page 7

After every 650-700 hours of operation you must
inspect brush motor carbon brushes for wear.
Replace the brush motor carbon brushes when they
are 1/2in. (13mm) in length.
GENERAL INFORMATION AND WARNINGS
 NSS machines are delivered with the SPE CBHD1-
XR-P-24-13 batery charger set to Curve #0 for
Crown 130AH batteries.
 Electronic automatic battery charger with
microprocessor suitable for any battery type.
 Universal input voltage:100-240 VAC
 Fully automatic charging cycle with electronic
settings; protected against overload, short-circuit at
clamps and reversed polarity.
 Before starting to charge, make sure the voltage of
the equipment suits the voltage of the battery, that
the charging current suits the capacity of the
battery and that the selected charging curve (for
lead-acid batteries or airtight gel batteries) is
correct for the type of battery to be charged. In
addition, make sure the rated input voltage of the
charger suits the available supply voltage and the
system is equipped with grounding.
 Pay attention to any remarks of the battery
manufacturer.
Front label on Battery Charger SPE CBHD1-XR-P
The set of 4-dip switches are easy to find (located under the round rubber plug next to the power cord) without
opening the charger. Use a small screwdriver to move the dipswitches up and down.
Red LED Yellow LED
CBHD1-XR-P DIPSWITCH LOCATION
OPERATING PRINCIPAL OF THE CBHD1-XR-P
When powering up the battery charger it will display
either the flashing Red LED or Green LED for 5
seconds while it checks the AC input voltage and the
DC battery voltage and decide whether or not to start
the charging process. Flashing Red LED at start up
indicates one of the two WET charging curves.
Flashing Green LED at start up indicates one of the
two AGM/GEL charging curves.If the battery is not
connected to the battery charger or if there is an
anomaly, the Yellow LED will flash.If the result is
positive after 1 second, the charging of the battery
will start with the Red LED on.The output relay closes
and the current of the first phase rises slowly until the
programmed nominal value is reached. If the user
disconnects the battey from the battery charger
during charging, the Red, Yello and Green LED's will
be on for 1 second. After that, the battery charger will
reset. The progress of the charging process is shown
by three LED's: Red, Yellow and Green as typical for
the battery charger product range. The Green LED
indicates the end of the charging or the last phase in
the case of a deep charging process. When charging
is finished, the relay is opened to disconnect.
OPERATION INSTRUCTIONS
 Plug the cord into a socket.
 The charging cycle progress will be shown by
Red,Yellow and Green LED indicators. At the end
of the charge, when the green indicator is on,
unplug the cord from the socket and operate the
machine.
Green LED