Delivery Scope; Intended Use; Technical Data; Noise/Vibration Information - Berner BHD-2/24 SDS+ BC+2 Notice Originale

OBJ_BUCH-1726-002.book Page 12 Monday, September 7, 2015 10:51 AM
Symbol Meaning
L Sound power level
wA
L Sound pressure level
pA
a Vibration total value
h
K Uncertainty

Delivery Scope

Rotary hammer, auxiliary handle and depth stop.
Application tools and other accessories shown or
described are not part of the standard delivery
scope.
A complete overview of accessories can be found
in our accessories program.

Intended Use

The machine is intended for hammer drilling in
concrete, bricks and masonry, as well as for light
chiselling work. It is also suitable for drilling without
impact in wood, metal, ceramics and plastic, as
well as for screwdriving.

Technical Data

The technical data of the machine are listed in the
table on page 144.
The values given are valid for a nominal voltage [U]
of 230 V. For different voltages and models for spe-
cific countries, these values can vary.

Declaration of Conformity

We declare under our sole responsibility that the
product described under "Technical Data" is in
conformity with all relevant provisions of the direc-
tives 2011/65/EU, until 19 April 2016:
2004/108/EC, from 20 April 2016 on:
2014/30/EU, 2006/42/EC including their amend-
ments and complies with the following standards:
EN 60745-1, EN 60745-2-6.
Technical file (2006/42/EC) at:
Berner Trading Holding GmbH
Bernerstraße 6
74653 Künzelsau
GERMANY
Armin Hess
Chairman of the Management Board
07.09.2015, Berner Trading Holding GmbH
Bernerstraße 6
74653 Künzelsau
GERMANY
12 | English

Noise/Vibration Information

The measured values of the machine are listed in
the table on page 144.
Sound emission values determined according to
EN 60745-2-6.
Vibration total values a (triax vector sum) and un-
h
certainty K determined according to EN 60745-2-6.
The vibration level given in this information sheet
has been measured in accordance with a standard-
ised test given in EN 60745 and may be used to
compare one tool with another. It may be used for
a preliminary assessment of exposure.
The declared vibration emission level represents
the main applications of the tool. However if the
tool is used for different applications, with different
accessories or insertion tools or is poorly main-
tained, the vibration emission may differ. This may
significantly increase the exposure level over the
total working period.
An estimation of the level of exposure to vibration
should also take into account the times when the
tool is switched off or when it is running but not ac-
tually doing the job. This may significantly reduce
the exposure level over the total working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as:
maintain the tool and the accessories, keep the
hands warm, organisation of work patterns.
1 609 92A 1DY • 7.9.15