Motor Protection; Various Sawing Processes - B+BTec Diamond3 3510RS Manuel D'utilisation

DIAMOND3
water pump is completely submerged.
Connecting to power supply
First, check whether:
• the line voltage corresponds with the
data on the machineís specifications
plate,
• there is a grounded power supply,
• the extension cord wire cross-section is
at least 2,5 mm

Motor protection

The motor is equipped with a thermal
safety switch for protection against an
overload. When the motor gets over-
heated, the switch falls back into its initial
position and can only be switched on
again after the motor is cooled down. The
switch also protects against power failure.
When the power returns, the motor will not
start on its own but must be switched on
by hand.
Installing the saw blade
WARNING! Make sure to dis-
connect the machine from the
power supply before fitting or
switching the saw blade or when
doing any maintenance on the
machine.
• Remove saw cover.
• Block the sawing spindle with the
8 mm Allen wrench.
• Unscrew the hexagon nut with the
wrench and remove the saw flange.
3510/15RS - 4015RS
®
.
2
(Attention: Left-handed screw thread.)
• Clean the saw flanges.
• Fit the saw blade on the centre ring of
the motor flange. (Check the direction
of rotation and make sure the blade is
well centered.)
• Mount saw flange and tighten with
the hexagon nut. Place saw cover and
tighten with the 2 knobs.
vArIous sAwIng
processes
One-step sawing
(Use only original saw blades as advised
by the manufacturer.)
• Move saw head down until the saw is
approximately 10 mm below the saw
table.
• Secure saw head with the two han-
dles.
• Place the material to be cut on the
sawing table and position against the
fixed stop and eventually the adjust-
able stop.
• Hold material to be cut with one hand
while making sure your hand is not to
close to the saw blade.
• Pull the saw head with medium force
with the other hand through the mate-
rial.
Multi-step sawing
During this sawing process the saw is posi-
tioned at the desired height and moved
back and forth through the material to be
cut until after a number of steps it is com-
pletely cut through.
• Place the material to be cut on the
sawing table and position against the
fixed stop and eventually the adjust-
able stop.
• Position the saw head at the desired
height
• Hold material to be cut with one hand
while making sure your hand is not to
17
GB