Unpacking And Set Up - B+BTec Diamond3 3510RS Manuel D'utilisation

GB DIAMOND3
the knobs.
Saw head
The saw head is constructed of welded
steel components. The height adjustment
of the saw head is kept in balance by a
spring. Two handles secure the saw head
at the desired height.
Saw cover
The saw cover is a welded steel plate
cap, simple to remove and install for
changing the saw blade by unscrewing
2 knobs.
Saw spindle
The motor flange is mounted on the saw
spindle. The saw flange is to be mounted
on the saw spindle with a hexagon nut
to clamp the saw blade. (Attention: Left-
handed screw thread.)
Saw table
The saw table is constructed of welded
stainless steel components, equipped with
anti-slip rubber and adjustable side stop.
Cooling system
The electrical water pump is switched on
simultaneously with the saw motor and
supplies cooling water to both sides of the
saw blade. A drain hole, with a plug, is
located in the water container. The mud
flaps prevent most of the water mist and
make sure most water flows back in the
water container.

unpAckIng And set up

Setting up
• Unpack the sawing machine and
inspect for any damaged parts.
• Install the legs in the sockets at the
underside of the water container and
fasten with the knobs.
• Level the sawing machine by adjusting
3510/15RS - 4015RS
®
the legs in the sockets and make sure
its stable.
Saw head
• Unscrew the transportation lock.
• By loosening the two handles the saw
head can be positioned at the desired
height.
• For 45° Jolly sawing the upper frame
with the saw head can be tilted at a
45° angle. By loosening the 2 handles
at the front and back of the machine,
the upper frame can be tilted until the
end of the factory predefined 45°
angle.
Cooling system
• Place the plug in the drain of the water
container.
• Fill up the container with water until the
16
ATTENTION! The saw head is
tightened by a spring and may
accidentally jump up when the
knob is loosened.
ATTENTION! Operating the
water pump without a sufficient
supply of water may result in
pump damage.