Tool Specifications - DeWalt DWMIIIFS Guide D'utilisation

WARNING: Always disconnect air supply: 1.) Before making adjustments; 2.)
When servicing the tool; 3.) When clearing a jam; 4.) When tool is not in use; 5.) When
moving to a different work area, as accidental actuation may occur, possibly causing
injury.
Safety Instructions - Loading Tool
WARNING: When loading tool: 1.) Never place a hand or any part of body in
fastener discharge area of tool; 2.) Never point tool at anyone; possibly causing injury.
Safety Instructions - Operation
WARNING: Always handle the tool with care: 1.) Never engage in horseplay; 2.)
Keep others a safe distance from the tool while tool is in operation as accidental
actuation may occur, possibly causing injury.
WARNING: Keep hands and body away from the discharge area of the tool. A
contact arm tool may bounce from the recoil of driving a fastener and an unwanted
second fastener may be driven possibly causing injury.
WARNING: Check operation of the contact arm mechanism frequently. Do not use
the tool if the arm is not working correctly as accidental driving of a fastener may result.
Do not interfere with the proper operation of the contact arm mechanism.
WARNING: Do not drive fasteners on top of other fasteners or with the tool at an
overly steep angle as this may cause deflection of fasteners which could cause injury.
WARNING: Do not drive fasteners close to the edge of the work piece as the wood
may split, allowing the fastener to be deflected possibly causing injury.
WARNING: This nailer produces SPARKS during operation. NEVER use the nailer
near flammable substances, gases or vapors including lacquer, paint, benzine, thinner,
gasoline, adhesives, mastics, glues or any other material that is -- or the vapors, fumes
or byproducts of which are -- flammable, combustible or explosive. Using the nailer
in any such environment could cause an EXPLOSION resulting in personal injury or
death to user and bystanders.
Safety Instructions - Maintaining the Tool
WARNING: When working on air tools note the warnings in this manual and use
extra care when evaluating problem tools.

TOOL SPECIFICATIONS

All dimensions in inches unless otherwise specified
MODEL LENGTH
17-1/4"
DWMIIIFS
(438 mm)
FASTENER SPECIFICATIONS
MODEL FASTENER
DWCS1500 or
DWMIIIFS
BCS1500
Tool Air Fitting
This tool uses a 3/8" N.P.T. male plug. The inside diameter should be .275" (7 mm) or
larger. The fitting must be capable of discharging tool air pressure when disconnected
from the air supply.
HEIGHT WIDTH
11-1/2" 3-1/8"
(292 mm) (80 mm)
CROWN GAUGE
WIDTH
1/2" (13 mm) 15-1/2 Ga.
4- ENG
WEIGHT
11.2 lbs
(5.1 kg)
FASTENER
RANGE
2" (50 mm)