Intended Use; Safety Instructions - DeWalt DWMIIIFS Guide D'utilisation

INTENDED USE

This DWMIIIFS Flooring Tool is intended for use by construction professionals for
installing unfinished hardwood flooring.
Precautions Regarding Use of this Tool to Install Prefinished Flooring
It may also be used to install prefinished wood flooring materials, however precautions
must be taken to assure that the finish will not be damaged by the tool. Before using the
tool on prefinished material, test a sample section to assure that the tool and installation
technique does not leave marks on the finish. This procedure must be followed for every
installation due to variations in flooring materials and condition of the tool.
Do not discharge fasteners into open air, concrete, stone, or any other material too
hard for the fastener to penetrate. Use of this tool by inexperienced operators must be
supervised.
WARNING: Some dust created by power sanding, sawing, grinding, drilling and
other construction activities contains chemicals known to the State of California to
cause cancer, birth defects and other reproductive harm. Some examples of these
chemicals are lead from lead-based paints, crystalline silica from bricks and cement
and other masonry products , and arsenic and chromium from chemically treated
lumber.
Your risk from exposure varies, depending on how often you do this type of work. To
reduce your exposure to these chemicals, work in a well-ventilated area, and work with
approved safety equipment, such as those dust masks that are specially designed to
filter out microscopic particles."

SAFETY INSTRUCTIONS

WARNING: EYE PROTECTION which conforms to ANSI specifications
and provides protection against flying particles both from the FRONT
and SIDE should ALWAYS be worn by the operator and others in the
work area when connecting to air supply, loading, operating or servicing
this tool. Eye protection is required to guard against flying fasteners and
debris, which could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is
worn. Eye protection equipment must conform to the requirements of
the American National Standards Institute, ANSI CAN/CSA Z94.3 and
provide both frontal and side protection. NOTE: Non-side shielded
spectacles and face shields alone do not provide adequate protection.
CAUTION: Additional Safety Protection will be required in some
environments. For example, the working area may include exposure to
noise level which can lead to hearing damage. The employer and user
must ensure that any necessary hearing protection is provided and
used by the operator and others in the work area. Some environments
will require the use of head protection equipment. When required, the
employer and user must ensure that head protection conforming to
ANSI CAN/CSA Z89.1 is used.
Safety Instructions - Air Supply and Connections
WARNING: Do not use oxygen, combustible gases, or bottled gases as a power
source for this tool as tool may explode, possibly causing injury.
WARNING: Do not use supply sources which can potentially exceed 200 p.s.i.g.
(14kg/cm ) as tool may burst, possibly causing injury.
2
WARNING: The connector on the tool must not hold pressure when air supply
is disconnected. If a wrong fitting is used, the tool can remain charged with air
after disconnecting and thus will be able to drive a fastener even after the air line is
disconnected possibly causing injury.
3- ENG