Bosch GIC 12V-5-27 C Professional Notice Originale page 30

30 | English
To remove the non-rechargeable/rechargeable batteries, press the release buttons (23)
of the cap (24) and pull off the cap. Pull out the cover (22) from inside the port (21).
Always replace all the batteries at the same time. Only use batteries from the same man-
ufacturer and which have the same capacity.
Remove the non-rechargeable/rechargeable batteries from the inspection cam-
u
era when not using it for longer periods. The non-rechargeable/rechargeable bat-
teries can corrode during prolonged storage in the inspection camera.
Operation with Lithium-Ion Rechargeable Battery (see figure B)
Use only the chargers listed in the technical data. Only these battery chargers are
u
matched to the lithium-ion batteries of your inspection camera.
Note: Lithium-ion rechargeable batteries are supplied partially charged according to in-
ternational transport regulations. To ensure full rechargeable battery capacity, fully
charge the rechargeable battery before using your tool for the first time.
To insert the charged rechargeable battery (14), slide it into the port (21) until you feel
it click into place and it is flush with the handle of the inspection camera.
To remove the battery (14), press the release buttons (23) and pull it out of the
port (21). Do not use force to do this.
Recommendations for Optimal Handling of the Battery
Protect the battery against moisture and water.
Only store the battery within a temperature range of −20 to 50 °C. Do not leave the bat-
tery in your car in the summer, for example.
A significantly reduced operating time after charging indicates that the battery has de-
teriorated and must be replaced.
Follow the instructions on correct disposal.
Fitting the camera cable (see figure C)
For operation of the inspection camera, the camera cable (1) must be fitted on the hand-
held device (13).
Push the connector of the camera cable (1) onto the camera connection (25) in the cor-
rect position until it clicks into place.
Removing the camera cable (see figure D)
To remove the camera cable (1), press the locking mechanism (26) and pull the con-
nector out of the handheld device (13).
1 609 92A 9RJ | (24.05.2024) Bosch Power Tools