Safety Information; Technical Data; Proper Use - EINHELL 45.133.77 Mode D'emploi D'origine

Anleitung_BT_CD_10_8_3_Li_SPK1:_
GB
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.

1. Safety information

Please refer to the booklet included in delivery for the
safety instructions.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (Fig. 1)
1. Torque selector
2. Changeover switch
3. ON/OFF switch
4. Battery pack
5. Pushlock button
6. Selector switch for 1st gear to 2nd gear
7. Quick-change drill chuck
8. Charging adapter
9. Battery charger
10. Battery capacity indicator
11. Switch for battery capacity indicator

3. Proper use

The cordless drill/screwdriver is designed for
tightening and undoing screws, as well as for drilling
in wood, metal and plastic.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
10
30.06.2009 9:34 Uhr
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

Voltage supply 10.8 V d.c.
Idling speed: 0-350/0-1200 rpm
Torque settings:
Forward and reverse rotation
Chuck clamping width max. 10 mm
Battery charging voltage 12 V d.c.
Battery charging current 500 mA
Mains voltage for charger 230 V ~ 50 Hz
Weight
Max. screw diameter:
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level 64 dB(A)
pA
K uncertainty
pA
L sound power level 75 dB(A)
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Drilling in concrete
Vibration emission value a ≤ 2,5 m/s 2
h
K uncertainty = 1,5 m/s 2
Screwing without hammer action
Vibration emission value a ≤ 2,5 m/s 2
h
K uncertainty = 1,5 m/s 2
Important!
The vibration value changes according to the area of
application of the electric tool and may exceed the
specified value in exceptional circumstances.
Seite 10
19+1
yes
1.2 kg
6 mm
3 dB
3 dB