Starting / Stopping The Engine - Stihl Km 130 R Notice D'emploi

English
Starting / Stopping the
Engine
Controls
7
3
2
1
1 Throttle trigger lockout
2 Throttle trigger
3 Slide control
Positions of slide control
4 STOP-0 – engine off – ignition is
switched off
5 F – normal run position – the engine
is running or can start
6 START – ignition is switched on –
the engine can start
12
Symbol on slide control
7 h – stop symbol and arrow. To stop
the engine, push the slide control in
the direction of the arrow on the stop
symbol (h) to STOP-0.
Starting
4 Press down the trigger lockout lever
N
and squeeze the throttle trigger
and hold them in that position.
N
5
Move the slide control to START
N
and hold it there.
6
Now release the throttle trigger,
N
slide control and trigger lockout in
that order. This is the starting
throttle position.
Set the choke knob (8)
N
9
8
g if the engine is cold
e for warm start – also use this posi-
tion if the engine has been running
but is still cold.
Press the manual fuel pump
N
bulb (9) at least five times – even if
the bulb is filled with fuel.
Cranking
Place the power tool on the ground
N
so that it rests on the machine
support:
If fitted: Remove the transport guard
N
from the cutting attachment.
To reduce the risk of accidents, check
that the working tool is not touching the
ground or any other obstacles – see also
"Starting / Stopping the Engine" in the
KombiTool instruction manual.
KM 130 R