Zibro H610 Manuel D'utilisation page 49

TROUBLESHOOTING
Check the following before contacting technical support:
Problem
The unit does not work.
Moisture is not
generated
The humidifier works,
but does not sufficiently
increase the relative
humidity.
The device does not
humidify.
Both "Dry" and "High
humidity" lights are
blinking at the same time
Can not set the
programmed setting
Operations stops
automatically after a few
minutes
Cause
The power cord is not
connected.
The water container is too full.
The water container has not
been replaced correctly.
"Empty" light is blinking.
The current humidity is higher
than programmed humidity.
The water container is empty.
The inside of the device is dirty.
The room is too large.
Too much moisture is absorbed.
There is too much ventilation
The air inlet filter is clogged.
The relative humidity in the
room in which the device is
operating is too high or the
temperature is too low.
The thermistor detects hot water
in the water container (over
40°C).
If "50" or programmed light is
blinking,humidity sensor is
malfunctioning.
If "Continous" light is blinking,
the thermistor is malfunctioning Contact your dealer.
If "40" and "60" of programmed
lights are blinking, heater is
disconnected.
Solution
Insert the plug into the wall
socket
Remove some water from the
water container.
Place the water container in the
correct position.
Fill the water container with
water.
If current humidity is higher
than programmed humidity, the
unit does not work to prevent to
much humidity.
Fill the water container with
water.
Wipe inside of the body with a
soft cloth.
We recommend using a
humidifier with a bigger
capacity.
We recommend using a
humidifier with a greater
capacity.
Reduce ventilation (e.g. close
curtains and shut doors).
Clean the air inlet filter.
It is normal that the device does
not humidify in these conditions.
Refill the water container with
cold water.
Contact your dealer.
Contact your dealer.
4
49