Zibro H610 Manuel D'utilisation page 46

OPERATION
CONTROL PANE
A
ON-/OFF-button
B
Timer button
C
SETTING
1 Insert the plug
2 Press the
light, the "SET HUMIDITY" light and "ON/OFF" light will switch on.
3 Set the desired humidity by pushing "
NOTE!
• If the "ROOM HUMIDITY" is higher than the "SET HUMIDITY" the unit does
not operate.
• If you set "continuous mode
humidification mode.
The device starts to humidify as soon as it is switched on. If the water container is empty
during the operation a buzzer will sound and the "empty
4 Press the
approximately 1 minute, because the unit has to cool down. Never switch off the unit
by pulling the plug out of the wall socket!
NOTE!
• If outside temperature is cold, the humidity capacity will be reduced.
• Please check the remaining amount of water in the container before use.
Allways switch off the device before filling the water container.
• When the unit is not being used, all water should be removed from the unit
and the water container.
HOW TO USE THE AROMA RESERVOIR
1 Switch the device off by pushing the
2 Open the aroma cap.
4
46
L
in the wall outlet.
ON/OFF button to switch the humidifier on. The "ROOM HUMIDITY"
" the unit works in the high "60%"
ON/OFF button again to switch the device off. This will take
B
C
A
- SETTING" button.
" light is blinking.
ON/OFF button.