Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
•
Now put the device you wish to teach-in to the switch actua-
tor (e.g. HomeMatic Remote Control, see the following fig.) into
teach-in mode. Please refer to the operating manual of the de-
vice you wish to teach-in for further information on activating the
teach-in mode.
If teaching-in was successful, the device LED (B) of the switch actuator
will flash green for one second. If teaching-in failed, the device LED will
light up green for two seconds. In this case, please try again.
After successfully teaching-in the device you can switch on and
off connected loads e.g. with the HomeMatic Remote Control
If no teach-in operations are carried out, teach-in mode is exited
automatically after 20 seconds. If other devices are also in
teach-in mode, they will be taught-in.
5.2.2
Teaching-in to a HomeMatic Central Control Unit
Your device can be conveniently
•
controlled and configured,
•
connected directly to other devices or
•
used in Central Control Unit programs
Start-up
31
Publicité
Chapitres
Table des Matières
