Start-Up; Simple Operating Functions On The Device; Teaching-In - HomeMatic HM-ES-PMSw1-PI Mode D'emploi

5

Start-up

5.1

Simple operating functions on the device

• Insert the wireless switch actuator with power metering into a
socket.
The device is immediately ready for operation and can be taught-in to a
HomeMatic CCU (or to other HomeMatic devices).
Via the channel button (A), connected loads can be controlled (switch on
and off) with a short button press.
Before being able to use and configure your device in the HomeMatic
system to control connected loads, the switch actuator has to be taught-
in first (see sec. „5.2 Teaching-in" on page 29).
5.2

Teaching-in

Please read this entire section before starting the teach-in
procedure.
Before being able to use your device with QIVICON, it has to be
taught-in to your QIVICON Home Base.
Therefore, please log-in to "Mein QIVICON" at www.qivicon.
com/login. There, please select "Gerät hinzufügen" and follow
the instructions.
To integrate the switch actuator with power metering into your HomeMatic
system and enable it to communicate with other HomeMatic devices (e.g.
HomeMatic Remote Control), you must teach it in first. You can teach-in
the switch actuator with power metering directly to other HomeMatic devic-
es or to the HomeMatic Central Control Unit
Start-up
29