How Our Unique Technology Works - Ecor Pro DryFan 8 Mode D'emploi

HOW OUR UNIQUE TECHNOLOGY WORKS

Your dehumidifier uses DryFan
uses a continuously rotating moisture absorbing
patented wheel termed a "Rotor".
A highly efficient yet low noise fan draws air into the
unit (Process Air) and forces it through a section of
the rotor. As the air passes through the rotor, the
honeycomb, of hygroscopic membranes absorbs
almost all of the moisture creating an extremely
dry airstream.
Most of this airstream (approx 85%) is discharged
directly through the 'Dry Air Outlet' .
However, a portion, (approx 15%) of this air (Regen
Air) is separated and directed through a special
heater bank (Regen Heater) where the air's
temperature is raised.
This heated air is then channelled back through a section of the Rotor.
As this hot air passes through the membranes, its higher temperature drives-out the previously
absorbed moisture and discharges it as warm wet air through the 'Wet Air Out' duct.
As the wheel rotates, this process of collecting and discharging moisture is continuous.
The wet air outlet is 40 mm in diameter making it easy to vent the moisture away using standard push fit waste
water connectors.
Water is not drained away as a liquid it is vented away similar to a tumble dryer.
+
|
®
technology and
•wet air exhaust
• dry filtered
air out
• patented dessicant rotor
UK
• patented
regen heater
• damp air in
5