How It Works - Ecor Pro D850E Mode D'emploi

available, one should be installed by a licenced electrician.
• Any service other than regular cleaning or filter replacement should be performed
by an authorized service representative. Failure to do so could result in a loss of
warranty.Your dehumidifier is supplied with an electrical cable and an earthed
plug. Should it be necessary to replace this plug at any time, you must use an
earthed electrical plug.
Warning! Never operate this appliance if it has a damaged cord or plug.
If the supply cord is damaged, it must be replaced by an approved service
representative or a similar qualified person in order to avoid any hazards.
There should be direct access to the electrical plug after connecting the power!
Do not use your dehumidifier under the following conditions:
If the power cable Where the power
wires are frayed cable may be
or cut damaged
When small If there is a risk of
children may be liquid falling on
left unattended the unit

HOW IT WORKS

See page 4, fig. 3
Your dehumidifier controls the Relative Humidity by passing the air through the
unit forcing the excess moisture to condens over the cooling elements.
This condensate water then flows safely into a fixed drain.
The dried air then passes through a final heat exchanger where it is slightly warmed
and re-enters the area at a slightly elevated temperature.
The level of demoistering is set with the humidistat control.
If an extension Close to a heat
cord is needed to source
reach an outlet
Where it may Where there is a
be damaged by risk of interference
chemicals by foreign objects
3
GB
This product is not
made for DIY repair