Main menu
Submenu
4. "SET GEAR"
5. "SET DRIVE
MODE"
6. "SET ROT. DIR."
1. "DRIVE
CHOICES"
7. "SET FUSE"
8. "SET WATER
VALVE"
967 - 002 - 11.06.2021
Adjustment
The connected wall saw has 2 mechanical gears:
1. (600-900 rpm)
2. (800-1200 rpm)
Set the necessary "DRIVE MODE" for the product:
•
"BLADE MAN" for wall sawing
•
"BLADE STD" for wall sawing
•
"WIRE" for wire cutting
•
"CHAIN" for chain sawing
Stop the product before change of direction of the blade. Select be-
tween:
•
"STANDARD"
•
"REVERSE"
To use full power output, the product must be connected to a 32 A fuse.
With a fuse that is lower rated, the power output must be lower to not
overload the fuse. Select the applicable fuse rated value that is related to
the connected product:
•
16A
•
25A
•
32A
The water flow is adjusted with the ball valve at the water connector inlet.
Select correct water regulation:
•
"ON" - The water valve is always open.
•
"AUTO" - The water valve opens when the dial is turned from its
closed position.
11