Troubie Shooting - Makita SJ401 Manuel D'instruction

TroubIe Shooting

WARNING:
Turn switch "OFF" and always remove plug from the power source before trouble shooting.
TROUBLE
Breaking blades
Motor will not run.
Vibration
NOTE:
There will always be some
vibration present when the saw
is running because of motor
operation.
NOTE:
Consult your local Service Center if for any reason your motor will not run.
PROBLEM
1. Wrong tension.
2. Over working blade.
3. Wrong blade application.
4. Twisting blade in wood.
5. Incorrect teeth per inch.
1. Defective cord or plug.
2. Defective motor.
3. Defective wire connections.
1. Improper mounting of saw.
2. Unsuitable mounting
surface.
3. Loose table or table resting
against motor.
4. Loose motor mounting.
1. Adjust blade tension.
2. Reduce feed rate.
3. Use narrow blades for cutting thin wood, wide blades for thicker
wood.
4. Avoid side pressure on blade.
5. Blade should have minimum 3 teeth in contact with workpiece.
1. Replace defective parts before using saw again.
2. Consult Service Center. Any attempt to repair this motor may void
warranty.
3. HAZARD unless repair is done by a qualified service technician.
1. See "MOUNTING SCROLL SAW TO WORKBENCH".
2. The heavier your work bench is, the less vibration will occur. A
plywood workbench will not be as good a work surfaces the same
size solid lumber workbench. Use common sense in choosing a
mounting surface.
3. Tighten table lock knob.
4. Tighten motor mounting screws.
REMEDY
13