Zolux 487041 Guide D'utilisation page 12

Attaching the collar strap:
FR
EN
PL
NL
ES
1/ With the On/Off Intensity
Dial going in first, insert the
PT
body of the anti-bark collar
into the collar strap.
Replacing the batteries:
- When the batteries are placed incorrectly, the LED indicator light may turn on, but the
unit will not operate properly.
- The unit operate properly when the LED indicator flash every 4 seconds.
- Please remove the plastic battery seals before installing the batteries.
Fitting the anti-bark collar Zolux :
A proper fit is necessary for the anti-bark collar to work optimally.
Both contact points must be in contact with your dog's skin at
all times for a consistent stimulation. A loose fitting collar can
cause the contact points to rub against the skin and cause
irritation. When properly fitted, you should be able to fit a
finger or two snugly in between the contact points and your
dog's skin.
TROUBLESHOOTING
When do I replace the batteries on my anti-bark collar?
- If the unit is not activating or the LED indicator does not turn on, the batteries may need to be
replaced. Overall battery life will be dependant on usage. With the anti-bark collar activating
around 10 times a day, the battery will have an average life of about 2-weeks.
- To clean the anti-bark collar, make sure the battery cover is closed and fully sealed, and wipe
down the unit with a damp cloth and some alcohol. Make sure the unit is completely dry
before use.
12
Pull the strap around the body of the iQ
No Bark Collar in the direction shown
Hold strap
here
2/ Pull the collar strap from the
opposite side of the On/Off
Intensity Dial over the rest of
the body.
- Using a coin, unscrew the battery cover counterclockwise.
- Insert two batteries with the plus (+) sides facing out.
- Check to make sure that the rubber gasket is in place, and
screw in the battery cover clockwise.
ATTENTION
Hold strap
here
3. Be sure that the collar
strap is wrapped fully
around the body of the
anti-bark collar.