Zolux 487041 Guide D'utilisation page 11

NOTICE
When first using the anti-bark collar, it is recommended that you start with the lowest
level. If the dog continues to bark, gradually increase the intensity level. Closely
monitor your dog's reaction to find the right stimulation level.
The LED indicator will flash for 1 second when the anti-bark collar has been turned
on, and every 2 seconds afterwards. If your dog does not bark for over 10 seconds,
the LED indicator will turn off and the anti-bark collar will go into a sleep mode to
conserve battery life. It will reactivate when your dog barks and a vibration/correction
needs to be made.
Functions:
1. Non-stimulating Pager vibration mode :
- Turn the intensity dial to P.
- When your dog barks, the anti-bark collar will vibrate twice.
2. Stimulation modes 1-10 :
- Stimulation levels from 1 to 10, with 1 being the lowest level and 10 being the
highest level.
- When the anti-bark collar is first activated by the dog's bark, the unit will give a
warning non-stimulating vibration. If the dog continues to bark, the unit will give a
non-stimulating vibration followed by a correction at the level it is set on.
The anti-bark collar has a preset delay of 15 seconds in-between corrections. Once the
unit activates, it WILL NOT activate again until 15 seconds has gone by. (The unit will
reset to the warning non-stimulating vibration after 17 seconds of a correction if the
dog does not bark.)
Testing the anti-bark collar :
- Turn the On/Off and Intensity Dial to (T), for the test mode. The LED indicator will
flash once, and after 2 seconds it will continue flashing every 2 seconds.
- Activate the collar by making sounds directly into the micro. The unit should now
vibrate twice. After waiting 15 seconds, repeat the test once more to verify that it is
fully functional.
When on the test mode, the sensor maybe sensitive enough that it may activate easily
by a quiet sound or tap.
FR
EN
PL
NL
ES
PT
11