Hansgrohe Metris C 15404 1 Série Instructions De Montage / Mode D'emploi / Garantie page 8

1
2
1
3
8
4 mm

5 mm
4 mm
English
Installation
Close the stops using a 4 mm
Allen wrench.
Cut the plaster shield so that it extends ¹⁄₁₆"
- ⅛" from the finished wall surface.
Seal the wall around the plaster
shield with waterproof sealant
(1).
Failure to seal the wall can lead
to possible water damage.
Remove the flush insert screw, flush insert, and
seals ().
Install the function block.
Tighten the screws using a 4 mm Allen wrench.