Cover Assembly - Husqvarna 966805003 Manuel Du Propriétaire

COVER ASSEMBLY

NOTE: For ease of assembly, you may wish
assistance from another person for mounting the cover
assembly to mower.
1. Lift and rotate cover to align the cover brackets with
support assembly tubes.
2. Slide the cover down over the support tubes until
secure.
MIDDLE CHUTE ASSEMBLY
1. Using the hacksaw, trim along the dashed line.
2. Place middle chute over the top end of the blower
assembly, lining up the blower latch and the acorn
nut on the middle chute.
3. Stretch bungee latch up onto acorn nut to secure.
Slide the upper chute discharge end into the hood
inlet and fit the lower end over middle chute. Secure
middle chute to upper as in Step 1.
4. Rotate the chute so the opening is facing
downwards toward the container bags.
ASSEMBLY
Trim Line
UPPER CHUTE ASSEMBLY
1. Slide upper chute onto middle chute, lining up the
middle chute latch and the acorn nut on the upper
chute.
2. Stretch bungee latch up onto acorn nut to secure.
Middle
Chute
Chute
Latch
Upper
Chute
7