Kinetico Water Systems SMF Serie Guide D'utilisation page 7

Install Your Kinetico Water Filtration System
What to Know Prior to Installation
• The Kinetico Water Filtration System is not to be used where water is
microbiologically unsafe or with water of unknown quality without adequate
disinfection before or after unit. Systems certified for cyst reduction may be
used on disinfected waters that may contain filterable cysts.
• For best performance and to maintain full capacity, it is recommended to
install a prefilter to protect this system.
• Do not install where line pressure is outside of 30-100 psi, or where
temperature is lower than 40˚F or exceeds 100˚F.
• Installation must comply with any existing local plumbing codes.
• The unit(s) must be protected against freezing. Failure to do so may result
in cracking of the filter and water leakage.
• This Kinetico Water Filtration System is designed for cold water line use
only. Passing hot water through the system may seriously damage filter
housing.
• Filter must be in contact with water at all times.
• Recommended pH range is 6 to 8.5.
• Recommended inlet pressure is 60 psi.
• Tools needed: drill, screwdriver, tube cutters (if hard plumbing: lead free
solder, heating device and flux).
Installation Instructions
Before Installing:
1. Determine plumbing requirements
2. Open box and verify all appropriate materials are present:
• Filter System
• Kit - Spare o-rings and lubricant
• Mounting Track(s)
• Spare E-clips
• Instruction Manual
Kinetico SMF Series Water Filtration System
7