General Description; Preparation For Use; Initial Checks; Instrument Power Supply - HT 5 Manuel D'utilisation

2. GENERAL DESCRIPTION

The instrument HT5 can be used as:
• Lamp test for gas filled lamps
• Continuity / diode test
• Single pole voltage test
• Torch light
The instrument can be also used for testing ballasts, starters, capacitors, resistors more
than the herewith lamp types:
• Fluorescent lamps
• Low pressure sodium vapour lamps
• High pressure sodium vapour lamps
• Neon tubes
• Mercury and metal halogen lamps

3. PREPARATION FOR USE

3.1.

INITIAL CHECKS

Before shipping, the instrument has been checked from an electric as well as mechanical
point of view. All possible precautions have been taken so that the instrument is delivered
undamaged.
However, we recommend generally checking the instrument in order to detect possible
damage suffered during transport. In case anomalies are found, immediately contact the
forwarding agent.
We also recommend checking that the packaging contains all components indicated in §
7.4. In case of discrepancy, please contact the Dealer
In case the instrument should be replaced, please carefully follow the instructions given in
§ 8.2.
3.2.

INSTRUMENT POWER SUPPLY

The instrument is powered by a single 9V battery type NEDA1604, JIS006P, IEC6F22
included in the package.
In order to prevent compromising its charge, the battery is not inserted in the instrument.
For battery installation, follow the instructions given in § 6.2
Replace the battery by following the instructions given in § 6.2
3.3.

CALIBRATION

The instrument has the technical specifications described in this manual. The instrument's
performance is guaranteed for 12 months.
3.4.

STORAGE

In order to guarantee precise measurement, after a long storage time under extreme
environmental conditions, wait for the instrument to be restored to normal condition (see §
6.2.1).
EN - 4
HT5