Accessories - Wahl AVALON 1290-0472 Mode D'emploi

Replacing the cutting set
Only replace a blunt or damaged cutting set with an original spare part. Spare parts can be ordered through your dealer or
our Service Center.
Before replacing the cutting set, switch the equipment off.
Lubricate the new cutting set before attaching.
Removing the blade set
· Press the release button (C) (Fig. 4a) towards the blade set and lift the blade set out of the housing (Fig. 4b).
· Lift the blade set out of its clip (Fig. 4c) and ensure that the clip remains folded out.
Attaching the blade set
· The clip must remain unfolded (can be prised open with a flat-bladed screwdriver) (Fig. 5a).
· Attach the new blade set onto the clip (Fig. 5b).
· Important note: Now switch on the device (Fig. 3). Fold down the blade set towards the housing, with the device running,
until it locates with an audible click (Fig. 5c).
Cleaning / Maintenance
Regular cleaning and maintenance will guarantee long service life for the equipment.
Disconnect from the mains before cleaning the appliance. Never clean the appliance when wet.
Do not use solvents or scouring agents!
Cleaning the air filter
· Clean the air filter regularly to ensure the supply of air.
· Remove the filter cover (Fig. 6a) and clean the air filter with the cleaning brush.
· Reinsert the filter cover until it locks into position (Fig. 6b).
Cleaning and caring for the cutting set
· In order to maintain a good and long cutting performance and durability of the appliance, the blade set must be cleaned
and oiled regularly.
· Animal clippers should be cleaned and oiled every 15 minutes during use.
· Fold down the blade set (Fig. 4b) and push the top blade to the side (Fig. 7). Remove cut hairs from the bottom blade and
the top blade by using the cleaning brush (Fig. 8).
The top blade must not be pushed out completely!
The blade set must not be unscrewed.
· After cleaning, return the top blade to its initial position (Fig. 7).
· Oil the marked areas of the blade set with one drop of oil each (Fig. 8).
· The top blade should be aligned in the center of the bottom blade.
· Reattach the blade set as described above, and restart the appliance for approximately 10 seconds to ensure the oil film is
evenly distributed.
· Only use our special blade set oil! This is available from your dealer or our Service Center.
Cleaning the case
· Clean the housing with a soft cloth, which may be dampened slightly.
Disposal in EU countries
D o not dispose of the appliance with domestic refuse. As part of the EU Directive governing the disposal of electric
and electronic appliances, the appliance is accepted free of charge by local waste collection points or recycling cent-
ers. Correct disposal will ensure environment protection and prevent a potential harmful impact on people and the
environment.
Disposal in non-EU countries
· Please dispose of the appliance at the end of its service life in an environmentally friendly manner.
· The battery pack contains NiMH batteries. In the interests of environmental protection, at the end of their service life
please do not dispose of these with domestic waste.
· Switch the device on so that the batteries are fully discharged.
· Use a screwdriver to unfasten the screws in the battery pack cover (Fig. 9).
· Disconnect cable connections from batteries and take out batteries (Fig. 10).
· Supply batteries with an appropriate collecting point.

Accessories

· Blade sets (see Page 32)
· Battery pack (see page 33)
en
Horse Clipper
9