Directions For Use; Important Safety Information; Charging Battery Pack - Wahl AVALON 1290-0472 Mode D'emploi

Directions for use

Important safety information

For your own protection from injuries and electric shocks, the following information must be observed when using electrical
equipment:
Read all the instructions before using the appliance!
· Only use the Horseline products to clip horses' coats.
· Only connect connector transformer to alternating current. Note the nominal voltage specified on the type plate.
· Never touch electrical equipment that has fallen into water. Disconnect from the mains immediately.
· Never use electrical equipment in the bath or shower.
· Always position or store electrical equipment where it cannot fall into water (e.g. wash basin). Avoid electrical equipment
coming into contact with water and other liquids.
· Only connect battery pack to mains to recharge in dry areas.
· Apart from when charging, always disconnect mains connector once device is no longer being used.
· Disconnect from the mains before cleaning the equipment.
· This appliance is not suitable for use by people (including children) with physical, sensory or mental disabilities or who
do not have the relevant experience or knowledge of using such appliance, unless under the supervision of or after hav-
ing received instruction in the use of the appliance by an individual who is responsible for their safety. Children should be
supervised to ensure they do not play with the appliance.
· Only use the equipment for the proper purpose described in the operating instructions
· Only use accessories recommended by the manufacturer.
· Never use the device if the power cable or connector transformer is damaged. In addition, do not use the equipment if it
is not working correctly, if it is damaged or if it has fallen into water. In these cases, send the equipment to our Service
Centre for inspection and repair. Only specialists properly trained in the handling of electrotechnical devices may repair
electrical equipment.
· Do not hold the appliance by the mains cable to carry it, and do not use the cable as a handle.
· Keep the mains cable away from hot surfaces.
· Make sure that the cable is not twisted or kinked when storing.
· Never insert or allow objects to fall into the openings of the equipment.
· Never use the equipment where aerosol (spray) products are being used or where oxygen is released.
· Only use genuine battery pack with temperature protection.
· A charging period of 3 hours is needed before first starting up.
· To protect against injury, never use the equipment if the cutting set is damaged.
· The equipment is safety-insulated and radio-screened. It meets the requirements of EU Directive 2004/108/EC regarding
electromagnetic compatibility and EC Low Voltage Directive 2006/95/EC.
Used batteries do not belong in household waste.
D ispose of used batteries in line with statutory rulings.
NiMH
Operation
Before each use, always check the lubrication of the cutting set. If necessary apply lubricating oil. When clipping
horses' coats for long periods of time, the cutting set must be cleaned and re-oiled at intervals.
Only connect device to battery pack once switched off.
Switch the equipment off after use and disconnect from the mains.

Charging battery pack

A separate battery pack supplies the horse clipper with power.
· This should be charged for approx. 3 hours before first starting up.
· Disconnect device from battery pack.
· Plug device plug connector of connector transformer into charging bush (IN) of battery pack (Fig. 1a).
· Plug connector transformer into socket (Fig. 1b). The charge monitoring display (I) on battery pack lights up.
· Once charging process is complete, charge monitoring display (I) on battery pack starts to flash.
· It should take around 3 hours for the appliance to charge to full capacity if the battery is empty.
· Once the battery pack has been fully charged, the horse clipper can then be used for more than 2.5 hours. This capacity
is reached after approx. 5 charging cycles.
Operation
· Put on carrier belt. You can use the simple fastening clip to secure the battery pack to the belt. The horse clipper can be
placed in the pocket provided for this purpose.
· Plug horse clipper plug connector into bush (OUT) of battery pack (Fig. 2).
· Use the on/off button to switch on the device (Fig. 3).
· After use, always switch device off (Fig. 3).
8