Operation - Cameo PHANTOM H2 Manuel D'utilisation

9 CANISTER
Fluid canister with screw cap and intake hose. The sinter filter on the end of the intake hose ensures that contaminant particles do not get
into the system and that the hose end is always at the lowest point of the canister. Completely disconnect the fog machine from the power
supply (remove the power plug) before filling the canister. Let the fog machine cool down sufficiently to prevent burn injuries. Unscrew the
lid of the canister and fill it with suitable fog fluid. Make sure that no fog fluid enters the device (take canister out of the fog machine). Put
the intake hose back into the canister and carefully close it with the lid. Never operate the fog machine without fog fluid.
HAZE OUTPUT OPENING
10
The haze output opening is located on the front side of the fog machine. Adjust the angle of the air guide as required. Ensure that the air
intake grille on the bottom of the device is not covered and that air intake in unimpeded. Ensure that no dust, sand, etc. can be drawn in.
Warning! The output nozzle is extremely hot. Do not touch! When setting up the haze machine, please refer to the points under "CAUTION!
IMPORTANT INFORMATION ON FOG MACHINES!" in the safety instructions.
11 HANDLE SCREWS
Handle screws for adjustment of the mounting bracket.
VENTILATION SLOTS
12
Ventilation slots are located on the top of the device. Ensure that the ventilation slots are not covered and that air can circulate freely.
13 SECURING POINT
Securing point for attaching the device on crossbeam installations.

OPERATION

NOTES
• Remove the protective film from the front of the hazer before first use.
• After connection to the power supply, the fog machine's heating phase will start (approx. 2 minutes). During this time, the display will
show "UP" and the fog output cannot be started. After the heating phase is completed, it show rEAd on the display.. In standalone operation,
"rEAd" (ready) is displayed to signal that it is ready for operation. When operated with the cable remote, the green LED will light up on the
remote control. Operation via a DMX controller has priority over both other modes of operation. Operation via the cable remote has priority
over standalone operation.
9
12
13
7