Setup And Installation; Technical Specifications - Cameo PHANTOM H2 Manuel D'utilisation

SETUP AND INSTALLATION

Place the fog machine in a suitable location on its preinstalled rubber feet. Install on a crossbeam using an optionally available transverse
clamp that is attached to the fog machine mounting bracket. Make sure that the device is firmly attached and secure it using a suitable
safety cable on the designated point (A). The maximum permitted incline of the fog machine is 30°. During setup and installation, follow the
information under "CAUTION! IMPORTANT INFORMATION ON FOG MACHINES!" in the safety instructions.
Important safety information: Overhead installation requires extensive experience, including the calculation of workload
limits and installed equipment, and periodic safety checks of all installation materials and devices. If you do not have these
qualifications, do not attempt to carry out the installation yourself; contact a professional company.

TECHNICAL SPECIFICATIONS

Article number:
Product type:
Type:
Heat-up time:
Heating element power:
Output volume:
Fluid consumption:
Canister volume:
Controller:
DMX input:
DMX output:
DMX mode:
DMX functions:
System settings:
Connection for cable remote:
Functions for cable remote:
Cable remote display elements:
Display elements:
Power supply connection:
Operating voltage:
Fuse:
Power consumption:
CLPHANTOMH2
Hazer
Hazer per vaporization principle
Approx. 2 minutes
600 W
Approx. 226 m³/min
Approx. 3,5 ml/min
0,8 l
DMX512, cable remote with 10 m cable
3-pin XLR, male
3-pin XLR, female
2-channel
Haze output, fan rotation speed
Dark mode on/off (display and canister illumination on/off)
5-pin DIN, female
Timer (interval, wind set, output), continuous haze output, manual haze output
Hazer ready for operation (green LED), continuous haze output (red LED), timer (yellow LED)
4-digit LED display
Permanently connected power cable with CEE 7/7 power plug
230 V AC / 50–60 Hz
F5AL 250 V 5x20 mm
620 W
A
9