EUROMAC EUROM Electric Weedburner Mode D'emploi page 24

Temperature settings:
With the on/off- and powerswitch you can select from two temperature settings.
Depending on the application, you can use the following settings:
Setting I 50 °C (venting / cooling)
Setting II 600 °C (weed burning / ignition BBQ or fire place)
The volume of air in each setting 500 l/minute
Always use with caution! Do NOT cover the ventilation openings during use as
it causes a risk of burns!
Never touch the hot nozzle!
Start to use
Option 1: Weed killer:
If using the device as a weed killer you must use the extension tube and the handle. Hold
the weed killer firmly by holding the end of the extension handle.
 Check that all of the relevant safety measures have been implemented.
 Ensure the extension handle is firmly fixed onto the device and that the device is
turned off.
 Lead the electrical cable away from the burner nozzle through the cable clamps on the
extension tube and handle.
 Install the nozzle to destroy weeds.
 Insert the plug into the socket
 Check to ensure the nozzle is not blocked before turning the device on.
 Slide the on/off and power switch to position II: the device will start to work.
 Allow the device about 45 seconds to warm up.
 To eliminate weeds, hold the nozzle over the weeds for about 5 seconds. During these
5 seconds the cell structure of the weed is destroyed. As a result, the weed dies within
a few days.
 It is not necessary to completely burn the weeds, 5 seconds is more than sufficient.
 For an efficient treatment the nozzle should be held around 0 to 5 cm above the weeds
 You switch the device off (temporarily) by sliding the power switch back to 0.
The effects are not visible immediately but will take a while before they can be seen. It is
more of a long-term effect.
Option 2: Lighter bbq / fire place:
The BBQ and fireplace lighter is always to be used without the extension handle.
 Attach the BBQ nozzle onto the device
 Place the nozzle under the coal or the wood.
 Ensure that the firelighter is properly positioned
 Insert the plug into the socket
 Check to ensure the nozzle is not blocked before turning the device on.
 Slide the on/off and power switch to position II: the device starts to work.