EUROMAC EUROM Electric Weedburner Mode D'emploi page 23

Replacing cables or plugs
If the power cord is damaged, it must be replaced by the manufacturer or its service agent
or a similarly qualified person, in order to avoid a hazard.
Immediately throw away old cables or plugs when they have been replaced by new ones.
It is dangerous to insert the plug of a loose cable in the wall outlet.
Using extension cables
Only use an approved extension cable suitable for the power input of the machine. The
minimum conductor size is 1.5 mm2. When using a cable reel always unwind the reel
completely
Inadequate extension cords can be dangerous. If an extension cord is used, it shall be
suitable for outdoor use, and the connection has to be kept dry and off the ground. It is
recommended that this is accomplished by means of a cord reel which keeps the socket
at least 60 mm above the ground.
CONTENTS
1 Weed Killer
1 Nozzle for weed control
1 Nozzle for BBQ
1 Extension tube
1 handle
1 Instruction manual
OPERATION
Assemble the extension handle
Slide the extension tube into the device as far as possible; until it clicks into place (there is
only one way to do this). Slide the other end of the extension tube into the handle until the
small catch pushes through the small hole. Check that both ends of the tube are
immovably in place. Press the 'extension tube lock button' or the 'handle lock button' and
pull the tube out of the device and the handle.
To install the nozzle:
The nozzles can easily be pushed over the hot air nozzle.
 The protruding points of the 'weed burner' nozzle must be slid as far as possible into
the slots of the burner nozzle. The nozzle must then be twisted approximately one
centimetre into the slot. Attention! The long side of the cap must be on top (this is the
side where the switch is located)!
 The 'barbecue/open hearth' nozzle must be slid onto the burner nozzle in such a way
that the round small holes are located on the underside (this is the side where the
stand is located).
Never touch the nozzles during or immediately after use of the device. The nozzles are
very hot.