EUROMAC EUROM Electric Weedburner Mode D'emploi page 22


Do not use this device in rain or damp surroundings, or near explosive or flam-
mable products.

Do not use the device on or near very dry spots to avoid fire

Always remove the plug from the socket when not using the device, when replacing
the nozzles or during maintenance of the device

Do not point the device at the same place for longer periods of time

Do not hold the device too close to the surface about to be worked on as the device
can overheat

Pay attention to the direct / indirect work- space as the heat can ignite flammable
materials, which are close by but not nec- essarily in view

Do not allow the hot parts of the device to touch the cord or other flammable
materials

The device should always be clean, dry and free of grease and oil

Do not use the appliance for purposes other than for which it is intended.
This appliance operates at a temperature of 600 degrees without visible signs
of this temperature (no flames), still there is a chance of fire risk. Watch out for
the hot air stream from the mouth piece. This air stream can cause burns.
When operating the appliance

If you are going to use the hot air gun, vapours and gas can be released during a
short time. This can be harmful for your health. Asthmatics can suffer hindrance of it;

Before connecting the plug to the mains voltage you have to check if the switch is in
position "0";

Keep the mains lead always away from the mouthpiece of the hot air gun;

Keep children and animals away from the appliance if you are using it.

Keep all parts of the body away from the metal heating head (incl. the nozzle). Do not
touch it before it is cooled down. Carry the appliance always and only by the insulated
handle, because the burner may come in contact with hidden wiring or its own
electrical cable.
Immediately switch off the appliance when:

Plug and/or cable are defective or damaged;

The switch is defective;

You smell or see smoke caused by scorched insulation from the hot air gun.
Electrical safety
When using electric machines always observe the safety regulations applicable in your
coun try to reduce the risk of fire, electric shock and personal injury. Read the following
safety instructions and also the enclosed safety instructions.
Always check that the power supply corresponds to the voltage on the rating
plate.
Class II machine – Double insulation – You don't need any earthed plug